TagFlash ECU Programmer has been successfully tested for reading and writing the Bosch EDC17C64 VAG ECU on bench, with 100% success.

To begin, please look at the image of ECU Bosch Edc17c64:

Step 1: Connect TagFlash with ECU EDC17C64 on Bench
To begin, configure the TagFlash tool as shown in the image below and connect the Tricore Cable according to the proper pinout.

Important: On some vehicles, reading in Bench Mode may not be possible, so in those cases, you will need to switch to Boot Mode.

Step 2: Reading/Writing Bosch EDC17C64 with TagFlash
For the reading and writing process, use the following driver settings:
Driver Path: Tool Boot Mode → Infineon Tricore Benchmode → Tricore SAK TC1797
Microcontroller: TC1797

Look at the following image showing the successful writing of the Bosch EDC17C64 with TagFlash.

Follow the above procedure, you will have a smooth operation when reading and writing the Bosch EDC17C64 VAG ECU on bench with TagFlash ECU Programmer.