Ecuhelp KT200 Read and Write BMW ZF8HP via OBD no problem
Great news for BMW tuners and transmission specialists: the ECUHELP KT200 has been successfully tested on BMW ZF8HP gearboxes via OBD with no problems, and the vehicle started perfectly afterward.…
Fix KT200II Failed OBD R/W Seat 1.8tsi dsg 2015 Simos 12
This article starts with one user’s feedback: What’s wrong i try stage1 to seat 1.8tsi dsg 2015 Simos 12…with ECUHELP kt200 everything goes fine, almost done then it says some…
How to Write ME2.1 with ECUHELP KT200 Bench Mode?
If you’re working with Bosch ME2.1 ECUs, you may have noticed that the KT200 software officially supports writing only via OBD. However, one user has successfully managed to write to…
KTflash/KT200 Plus read write EDC16C39 on Bench, DTC Off
Today we use ECUHELP KT Flash to read and write EDC16C39 data on bench, and do DTC Off. 1. Take out the dongle with the protocol enabled (ECU/Bosch EDC16/ME9-series Module…
How to Read/Write Nissan EMS3155 ECU Using KT200?
ECUHELP KT200 has been successfully tested for reading and writing Nissan EMS3155 CASE TC1782 ECU. read password via OBD okay Read and write the ECU Boot mode okay, checksum okay…
ECUHELP KT200 OBD Read and Write Man TGX 18.440 E5 EDC7C32
ECUHELP KT200 has been successfully tested for reading and writing Man TGX 18.440 E5 EDC7C32 via OBD. KT200 Connection Guide for Man TGX 18.440 E5 EDC7C32: Connect the multifunction cable…
ECUHELP KT200 Read and Write Visteon DCU102 Boot Mode
ECUHELP KT200 is a powerful ECU programmer capable of reading and writing Visteon DCU102 found in Ford and PSA vehicles. A successful test was performed on a 2010 Citroën Jumper…
KT200II/KT200 Read and Write BMW MSV70 BDM Mode
ECUHELP KT200II / KT200 ECU Programmer is tested to read/write BMW MSV70 BDM Mode without any problem. How do you use KT200 to read/write BMW Siemens MSV70 BDM mode? Kit…
KT200 read write Mazda cx3 skyactive 1.5l 105ps ecu s552 via OBD
Mazda cx3 skyactive 1.5l 105ps Ecu: s552 Read via obd: 46min Write: 9min checksum ok With ECUHELP KT200 ECU Programmer Please take a look at the ECU s552 outlook. And…
How to Fix KT200 Citroen edc17cp42 “Non-erasable sector in Bench mode”?
When attempting to write a Citroën EDC17CP42 ECU using ECUHELP KT200 bench mode, you might get the error: “End Writing. ADDRESS 018000: Non-erasable sector in Bench mode.” (Example shown below)…