Can ECUHELP KT200 Read DCM3.2ap in SsangYong Rexton?
KT200 is capable of reading and writing DCM3.2 (MPC 55x/56x) ECUs in Jtag mode, it does not support DCM3.2ap.

Required Tools:
To successfully perform the reading process, you will need the following tools and cables:

Multifunction Cable (Cavo multifunzione)
Delphi Adapter (Adattatore Delphi)
Grey Flat Cable (Cavetto flat grigio)
Dip/Sip Connectors (Connettori dip/sip)

Connect the multifunction cable as shown in the diagram below:

Solder the dip/sip connectors onto the PCB:

Insert the Delphi adapter in reverse, as depicted in the photo:

To read and write the ECU, make sure to use the appropriate driver and settings:

Select the following driver in KT200:
→ BDM / JTAG MODE
→ BDM MPC
→ MPC55x/56x

Conclusion:
ECUHELP KT200 is able to read/write DCM3.2 (MPC 55x/56x) ECUs in Jtag mode, but not DCM3.2ap. Ensure you have the required tools and cables mentioned above, and follow the provided connection setup and driver settings for successful reading and writing.

Note: Always exercise caution and refer to the manufacturer’s guidelines when working with ECUs.