This article serves as a comprehensive guide on how to use TagFlash ECU Programmer to read and write Mercedes Sprinter EDC16CP31 ECU in bench mode.

Test Report:
TagFlash has been successfully tested on a Mercedes Sprinter with EDC16CP31 ECU. All operations including read, write, and automatic checksum calculation were executed flawlessly in bench mode.

Step-by-Step Guide:
1. Identifying the ECU:
Start by locating and identifying Mercedes EDC16CP31 ECU.

2. Establishing the Connection:
Proceed to connect TagFlash to EDC16CP31 ECU using the Bench Box.
Ensure all connections are secure and properly set up.

3. Reading the ECU:
Initiate the read operation on the EDC16CP31 ECU.
Ensure the process reaches 100%, confirming a successful read.

4. Writing to the ECU:
Following the successful read, proceed to write to the EDC16CP31 ECU.
Confirm that the writing process also reaches 100%.

5. Pinout Reference:
For further assistance and accurate connection, refer to the TagFlash Pinout specific to the Mercedes EDC16CP31 model.

Conclusion:
With this guide, users are equipped with a clear and concise procedure for using TagFlash to bench mode read/write/automatic checksum Mercedes EDC16CP31 ECU.