Numerous users are reading and writing Bosch MEVD17.2.7 using ECUHELP KT200 ECU programmer in Bench/ Boot mode , a common unit found in several vehicle brands such as BMW, Mini, Citroen, and Peugeot.One such user recounted a seamless experience KT200 read 2011 BMW 535I 3.0 gas MEVD17.2.Y . It doesn’t have an option to read ext flash, because there is no ext flash existing in this hardware, so no option to read it, the internal flash contains Maps and processor instructions, eeprom.

Insight into KT200’s Operation with BMW MEVD17.2:

The seasoned engineers at ECUHELPshop.com validate the KT200’s compatibility with Bosch MEVD17.2.7 – TC1797, as outlined below:

BMW
Bench Read/Write: Confirmed
Boot Read/Write: Confirmed

Mini
Bench Read/Write: Confirmed
Boot Read/Write: Confirmed

Citroen
Boot Read/Write: Confirmed

Peugeot
Boot Read/Write: Confirmed

Wiring Protocols for KT200 Bosch MEVD17.2.7:

1. On Bench mode, KT200 Read/Write BOSCH MEVD17.2.7 [ 1797 ] – BMW, Mini [Gasoline]

Connect the multifunction cable as follows:

To read and write use the following driver:
→ BENCH TRICORE
→ BMW/MINI
→ TC1797 – BMW
→ MEVD17.2.7

2. In Boot Mode, KT200 Read/Write BOSCH MEVD17.2.7 [ TC1797 INT.F.] – BMW, Mini,Citroen, Peugeot

Kit to use:
– Multifunction cable

READ AND WRITE ECU:

Connect with the multifunction cable the following pinout and the boot shown below.
Use the driver:
→ TOOLS BOOT MODE
→ INFINEON TRICORE Boot
→ SAK TC1797

ATTENTION:
If the password error message appears at the beginning of the reading, proceed as follows:

PASSWORD SEARCH
Disable the boot mode by unsoldering the gray wire. Connect the pinout below.
Use the driver:
→ TOOLS BOOT MODE
→ INFINEON TRICORE Tool Password
→ OBD PASSWORD TPROTV08 BMW – MINI
→ Click on “Find Password” and follow the software messages.

Upon successful retrieval of the password, revert to STEP 1 to proceed with the read-write operations on the control unit.