ECUHELP KT200II ECU Programmer is tested 100% ok to read/write DCM7.1B PSA Boot Mode.

Kit to use:
– Multifunction cable
– Bench Box V.2

READ AND WRITE ECU:
With the multifunction cable connect the following pinout and the boot shown in the picture on the following pages, use the bench box v.2.

Use the driver:
→ TOOLS BOOT MODE
→ INFINEON AURIX Boot
→ BOOT AURIX TC297 PSA DCM7.1A/B

One of the boot pins is located under the processor. We recommend the use of a spring-loaded needle to connect it.

Below is the boot mode:

The view from above:

The connection example is shown on the next page..

As an alternative to the boot pin under the processor, it is possible to connect this pad on the underside of the board. Therefore, this pad is in common with the pin under the micro:

Also, ECUHELP KT200II can r/w DCM7.1B PSA OBD Mode:
https://www.ecuhelp.org/obd-read-and-write-dcm-7-1b-using-ecuhelp-kt200ii/