KT200 Read Write Mercedes GL350 EDC17CP10 boot mode

Byadmin

Jul 5, 2024 KT200II Test Reports

This article provides a detailed guide on using the ECUHELP KT200 ECU Programmer to read and write the ECU data of a Mercedes GL350 EDC17CP10 in boot mode.

Equipment Needed:
ECUHELP KT200 ECU Programmer
Mercedes GL350 with EDC17CP10 ECU
Multifunction cable

Step-by-Step Instructions:
Connect with the multifunction cable the following pinout and the boot shown below.
Use the driver:
→ TOOLS BOOT MODE
→ INFINEON TRICORE Boot
→ SAK TC1796
KT200 Read Write Mercedes GL350 EDC17CP10 boot mode-01

KT200 reading data from EDC17CP10.
KT200 Read Write Mercedes GL350 EDC17CP10 boot mode-03

KT200 writing data to EDC17CP10.
KT200 Read Write Mercedes GL350 EDC17CP10 boot mode-04

Conclusion:
By following these steps, you can effectively read and write the ECU data of a Mercedes GL350 EDC17CP10 in boot mode using the KT200 ECU Programmer. Ensure that all procedures are followed carefully to avoid any potential issues and to maintain the integrity of the ECU data.