ECUHELP KT200 Offline Workstation is able to read and write ECU and TCU for Car Truck Motorbike Tractor Boat on Bench, via OBD, in Boot, in BDM / JTAG in offline mode. It is a combination of the KT200 full version and the KT200 offline dongle.

Before using the Offline Workstation software, there are four essential steps to set up the KT200 USB dongle.

1. First, connect the device (as shown in Figure 1), and then proceed with running the setup and installing the KT200 software (as shown in Figure 2).

2. After installing the KT200 software, ensure that the C drive has a minimum capacity of 15Gor more.

3. confirm that sufficient space is available to run the installation of KT200_ftp.

4. After completing the installation process, insert the dongle and run the KT200.exe program to activate the first update.

5. Finally, complete the activation, and then open the software to start using the Offline Workstation.

Once these steps are completed, the setup process is finished, and the software is ready to be used.

Here is one common question:

ECUHELP KT200 Offline Workstation pop-up message “License expired, do you want to plug kt200 device and connect to the internet to update license? Yes to update, no to exit!”.

Solution:

Please follow the pop-up message to plug kt200 device into the computer and connect the

Internet to update the license, it only takes you less than 1 second.

Got any questions on how to use ECUHELP KT200 Offline Workstation, please contact tech support: WhatsApp: + 8618205996549, Email: Sales@ECUHELPshop.com.

Thanks!