TagFlash ECU Programmer is tested and able to work with Renault 2018 Continental SID310, OBD Full read – R/W/Checksum OK.

Look at the following 3 images which show TagFlash read/write SID310 100% ok.

The TagFlash wiring diagram of ECU Siemens Continental SID310 – TC1791 Internal Flash:

STEP 1:
To find the password you must to connect the tool by OBD plug on the car and use the driver:
OBD TOOL PASSWORD SID310
RENAULT – NISSAN – MERCEDES
After that, you will disassemble the car’s control unit and set it in Boot mode like in next step 2.
(Attention: if you don’t find a password on the car you must try on the table connecting the pinout.)

STEP 2:
Set in Boot mode the ECU, so connect the following pinout and solder the resistances/link shown in the figure below.
Use the driver:
BOOT MODE TRICORE SAK TC1791