KT200 II Read and Write Renault Scenic EDC16CP33 2.0 DCI on Bench

Byadmin

Sep 4, 2024 KT200II Test Reports

ECUHELP KT200 II ECU Programmer has been successfully tested for reading and writing the Renault Scenic EDC16CP33 2.0 DCI ECU on bench. The entire process takes approximately 1 minute and 15 seconds.

Below are images that demonstrate the process of writing the EDC16CP33 using the KT200 II.

KT200 II Read and Write Renault Scenic EDC16CP33 2.0 DCI on Bench-01

KT200 II Write Renault Scenic EDC16CP33 2.0 DCI on Bench-02

For a successful reading and writing operation, please refer to the KT200 II wiring diagram for the BOSCH EDC16 CP33 [MPC561/2] – applicable for Renault and Nissan diesel vehicles:

Connect the Multifunction Cable using the Bench Box as shown.

KT200 II Read and Write Renault Scenic EDC16CP33 2.0 DCI on Bench-03

Attention: If the ECU does not enter Bench Mode, connect as follows:

KT200 II Read and Write Renault Scenic EDC16CP33 2.0 DCI on Bench-04

Example of Connection:

KT200 II Read and Write Renault Scenic EDC16CP33 2.0 DCI on Bench-05

To read and write, use the following driver settings:

Mode: BENCH MODE

Brand: [brand]

Processor: MPC561/2 – [brand]

ECU Type: EDC16 CP33

Conclusion:

ECUHELP KT200 II ECU Programmer is a reliable tool for efficiently reading and writing the Renault Scenic EDC16CP33 2.0 DCI ECU on bench. By following the correct wiring setup and using the appropriate driver, users can achieve successful ECU operations in a short amount of time.