ECUHELP KT200II ECU programmer has been successfully tested for reading and writing the Iveco EDC17CP52 ECU in bench mode. This guide provides a step-by-step process to ensure a smooth and successful operation.

Step 1 . Use the KT200II multifunction cable and connect it as shown below:

Attention: Some controllers enter bench mode with the following pinout. Therefore, if it does not communicate in bench mode, connect as follows:

Step 2 . Once the ECU is correctly connected, proceed with reading and writing by selecting the appropriate driver in the KT200II software:
→ BENCH TRICORE
→ IVECO
→ TC1797 – IVECO
→ EDC17 CP52

This guide guarantees efficient and safe reading and writing of Iveco EDC17CP52 bench mode using ECUHELP KT200II programmer.